8x170 vs. 8x6.5 Drill Templates: Which Direction Do You Need?
When you're matching eight-lug wheel bolt patterns during an axle swap, the direction matters. Start with the bolt pattern you have, then choose the pattern you want to drill. CNA Fabrication makes two different drill templates for these opposite directions. They are not interchangeable.
Quick comparison
| Existing bolt pattern | New pattern to locate | Identifying cutouts | Product |
|---|---|---|---|
| 8x170 (Ford) | 8x6.5 | Half-circle cutouts above the existing-pattern holes | 8x170 → 8x6.5 Drill Template |
| 8x6.5 | 8x170 (Ford) | Half-cut diamond shapes at the existing-pattern holes | 8x6.5 → 8x170 Drill Template |
Starting with 8x170? Choose the half-circle template.
The 8x170 → 8x6.5 template locates the new 8x6.5 pattern from existing Ford 8x170 studs. CNA originally designed this version around 1999–2004 Ford Super Duty Dana 60 applications and has also confirmed fit on 2005-and-newer Ford Dana 60 hubs. This does not establish compatibility with every hub, stud or axle variant. See the forward template.
Starting with 8x6.5? Choose the half-diamond template.
The reverse 8x6.5 → 8x170 template locates the new Ford pattern from existing 8x6.5 studs. Customers have reported using this direction on some older Ford and Chevrolet eight-lug applications, but CNA has not independently verified those specific applications. Confirm your exact parts and intended machining before ordering. See the reverse template.
What does the template do?
Each template is a laser-cut 3/16-inch steel drilling-location guide. Its starting-pattern holes position it over existing studs; its other holes indicate where the new pattern would be drilled. CNA's product specifications call for a 39/64-inch drill bit and recommend a drill press or mill to help keep holes straight.
A template is not a wheel adapter, a completed hub conversion, or a guarantee that a particular hub can safely be modified. Hub identification, accurate machining, appropriate studs, installation, clearances and final fitment remain separate checks. Validate the actual components and required stud-hole fit rather than assuming the nominal bit size guarantees a safe press fit.
Three checks before ordering
- Identify the bolt pattern already on your hub.
- Identify the new bolt pattern you intend to drill.
- Verify your exact hub, studs and machining plan. A shared bolt pattern alone does not establish compatibility.
Bottom line: 8x170 → 8x6.5 uses the half-circle template. 8x6.5 → 8x170 uses the half-diamond template. If you're unsure about the direction or your particular application, contact CNA before ordering.

Start: 8x170 → Drill: 8x6.5
Start: 8x6.5 → Drill: 8x170