MIG Gun Holder Kit - DIY
Vendors and Bulk Buyers Welcome! Click "Contact us"
- Stop the Flop! Get Your Torch a Solid Place to Rest.
- Weld it Yourself, then Enjoy Using it in the Shop.
- Combines our Popular Welding Kit Style with a Useful Shop Tool.
- Comes with a Nasty 120lb Pull Disk Magnet and Mounting Hardware.
- DIY Means it's Fun to Make, and Saves you Money.
If you've spent much time behind a wire feed torch, you've undoubtedly witnessed your expensive MIG gun fly off the table with unreasonable speed at least once. Stop the flop with our CNA Fabrication torch holder. This weld-it-yourself kit is great welding practice, and a lot of fun. Once built, it becomes one of the handiest tools in your shop. Comes with a stupid strong 120lb disk magnet that will keep that snake of a torch in place between beads. Can't use the magnet on your bench? Use the supplied mounting hardware to bolt this fine piece of equipment to any surface. Made in the USA.
Customer Reviews
Just wanted to get something to practice welding on and liked the idea of a holder for my mig handle. Well, I love this thing. Obviously I’m not the best welder or even a good one. But I love the way this turned out. Checking out their website to buy more kits.
Compared to the other "typical" MIG torch holder I have, this one handles the weight of the torch and its cord. No tip-overs so far in about 16 hours of use. Magnet is stronger than other holders, which helps. Instructions are just a diagram sheet. If you want their cutout logo to read correctly from the outside, watch which way you bend the top to 45 degrees. It took about 20 minutes to assemble and grind welds.
Great quality. Fun little welding project.
Just started welding and been using CNA from the get go and from material to shipping from laying a bead im so happy with them i keep ordering. Just did the mig gun holder and as my second project i was so excited with my progress and the material from CNA.
This kit was a lot of fun to put together. I started with my welder's recommended settings for 1/8 inch steel, but I had to turn the heat down quite a bit because I was welding on the edges of the metal. One thing is for certain about this kit, the magnet is NO JOKE.
